SPIE Photonics West: Q&A with Ryan Shelton of PhotoniCare

Medical technology companies are empowering consumers to better grasp their own health by bringing technology closer to the consumer via cost reduction while increasing access and availability. As SPIE Photonics West begins, we caught up with Ryan Shelton, the CEO … Continued

As parts go micro, gate placement becomes a challenge.

Scott Byal As technology miniaturizes, traditional design engineering aspects of injection molded parts are now causing problems. When looking at the micro mold gate, where polymer enters the mold cavity, only a small percentage of part geometry and surface area … Continued

BIOMEDevice: Q&A with Jordi Parramon of Verily

Is the line between clinical and consumer health tech blurring? Does it even exist anymore? This week we will be hanging out with best minds in med-tech and biomedical device manufacturing, design, and creation are descending on San Jose CA … Continued

Scott Byal Article For Design World’s “Make Parts Fast”

Senior Project Engineer, Scott Byal gets quite a few questions and is constantly solving problems for our clients. One specific question revolves around gate placement, gate drag and how simple things can derail large multi-million dollar projects. Injection molding enters … Continued

ID Tech Ex Show: Q&A With Dr. Radislav Potyrailo

Dr. Radislav Potyrailo, Principal Scientist-Micro & Optoelectronics at GE will be speaking at ID Tech Ex in Santa Clara this week and, we caught up with him to give us a snapshot of the past and future of sensors reliability. … Continued

Compamed: Q&A With Dr. Justin F. Gaynor

COMPAMED has cemented its place as a leading international marketplace of precision supplies for the medical manufacturing space and we caught up with Dr. Justin Gaynor, Vice President, IntraSense at SMI Pressure Sensors who is speaking at the event on … Continued

MD&M Minneapolis: Q&A w/ Audrey Turley of Nelson Labs

We caught up with Audrey Turley ahead of her educational discussions for MD&M Minneapolis to ask about her take on biological evaluation plans and ISO 10993-1. Turley is the Senior Senior Biocompatibility Expert at Nelson Labs and is giving two … Continued

MD&M Minneapolis: Q&A With Andrew DiMeo of Trig

We caught up with Andrew DiMeo ahead of his educational discussion for MD&M Minneapolis. DiMeo is an Innovation and Design Coach with Trig and we asked him about human-centric design, prototyping challenges prototypers to deal with, and negative design patterns … Continued

BIOMEDevice. What Is It?

BIOMEDevice is held twice annually. Once early summer in Massachusets’ Boston Convention Center, and in the winter inside California’s San Jose Convention Center. The dual conferences focus on medical technology and draw thousands of med-tech professionals, executives and knowledgeable keynote … Continued

Our Recycling Journey Spotlighted In Quartz!

Our path to zero waste is nothing short of amazing, and we haven’t told that story publicly until now. This week, Quartz ran an article outlining our entire journey, how we accomplished our zero-waste goals, and how other manufacturing companies … Continued