MD&M West Brings New Tech and Prolific Voices

The annual MD&M West trade show and conference always bring the most cutting edge technology to the forefront. It also brings the manufacturing and technology industries most prolific voices and minds to discuss the biggest challenges in the industry. Voices … Continuado

SPIE Photonics West: Q&A with Ryan Shelton of PhotoniCare

Medical technology companies are empowering consumers to better grasp their own health by bringing technology closer to the consumer via cost reduction while increasing access and availability. As SPIE Photonics West begins, we caught up with Ryan Shelton, the CEO … Continuado

As parts go micro, gate placement becomes a challenge.

As technology miniaturizes, traditional design engineering aspects of injection molded parts are now causing problems. When looking at the micro mold gate, where polymer enters the mold cavity, only a small percentage of part geometry and surface area is affected. … Continuado

BIOMEDevice: Q&A with Jordi Parramon of Verily

Is the line between clinical and consumer health tech blurring? Does it even exist anymore? This week we will be hanging out with best minds in med-tech and biomedical device manufacturing, design, and creation are descending on San Jose CA … Continuado

Scott Byal Article For Design World’s «Make Parts Fast»

Senior Project Engineer, Scott Byal gets quite a few questions and is constantly solving problems for our clients. One specific question revolves around gate placement, gate drag and how simple things can derail large multi-million dollar projects. Injection molding enters … Continuado

Compamed: Q&A With Dr. Justin F. Gaynor

COMPAMED has cemented its place as a leading international marketplace of precision supplies for the medical manufacturing space and we caught up with Dr. Justin Gaynor, Vice President, IntraSense at SMI Pressure Sensors who is speaking at the event on … Continuado

MD&M Minneapolis: Q&A With Andrew DiMeo of Trig

We caught up with Andrew DiMeo ahead of his educational discussion for MD&M Minneapolis. DiMeo is an Innovation and Design Coach with Trig and we asked him about human-centric design, prototyping challenges prototypers to deal with, and negative design patterns … Continuado