News Page Featured

Archivos

As parts go micro, gate placement becomes a challenge.

Scott Byal As technology miniaturizes, traditional design engineering aspects of injection molded parts are now causing problems. When looking at the micro mold gate, where polymer enters the mold cavity, only a small percentage of part geometry and surface area is affected. In micro molding however, the gate becomes a part feature. This poses problems…

ID Tech Ex Show: Q&A With Dr. Radislav Potyrailo

Dr. Radislav Potyrailo, Principal Scientist-Micro & Optoelectronics at GE will be speaking at ID Tech Ex in Santa Clara this week and, we caught up with him to give us a snapshot of the past and future of sensors reliability. He will be speaking this week on wearable gas and physiological sensors and boosting their…

Compamed: Q&A With Dr. Justin F. Gaynor

COMPAMED has cemented its place as a leading international marketplace of precision supplies for the medical manufacturing space and we caught up with Dr. Justin Gaynor, Vice President, IntraSense at SMI Pressure Sensors who is speaking at the event on safety considerations in invasive pressure sensing. Q&A With Dr. Justin F. Gaynor Accumold: What best…

MD&M Minneapolis: Q&A With Andrew DiMeo of Trig

We caught up with Andrew DiMeo ahead of his educational discussion for MD&M Minneapolis. DiMeo is an Innovation and Design Coach with Trig and we asked him about human-centric design, prototyping challenges prototypers to deal with, and negative design patterns in med-tech. DiMeo’s presentation is titled The Art & Science of Prototyping on the Path…