Designing low profile, ultra thin, wearable medical devices is a design challenge even for the world’s leading engineers. Tolerances are […] Read Moreabout LinkedIn Live: DFM for low profile wearable med devices
News Page Featured
Medical micro molded cannula deep-dive
The following presentation by Craig Tappe from Accumold’s sales engineering team focuses on medical micro molded cannulas, specifically thin-wall cannula […] Read Moreabout Medical micro molded cannula deep-dive
Avoiding the pitfalls of rapid scale in medtech.
Top-tier biotech and medtech engineers, R&D managers, and strategic supply chain managers need the ability to scale quickly to meet […] Read Moreabout Avoiding the pitfalls of rapid scale in medtech.
Why engineers water down part design
If you’ve worked with any injection molders for thin parts, you may have seen a dreaded no-quote. In the best […] Read Moreabout Why engineers water down part design
Preventing IP theft in medtech manufacturing
Preventing IP theft in medtech manufacturing is more than revenue. It hurts patient results. This reason alone should motivate your […] Read Moreabout Preventing IP theft in medtech manufacturing
Overview of silicone micro molding
Engineers at leading OEMs are constantly solving a Rubik’s cube of manufacturing challenges. One size adjustment or resin change can […] Read Moreabout Overview of silicone micro molding
The micro molded thin-wall cannula
Over five years, Accumold has perfected the micro molded thin-wall cannula, especially when it comes to high-volume production. This moves […] Read Moreabout The micro molded thin-wall cannula
DMACC talks Accumold Scholars with Iowa Manufacturing Podcast
Last week, Kim Didier shared the Accumold Scholars story on the Iowa Manufacturing Podcast! Didier is the Executive Director of […] Read Moreabout DMACC talks Accumold Scholars with Iowa Manufacturing Podcast
Hot Tech: The blurring line between wearables and prosthetics
We’re at the Wearable Technologies (WT) Conference this week in San Francisco and caught up with featured speaker, Stanford Professor Steve […] Read Moreabout Hot Tech: The blurring line between wearables and prosthetics
Soft or Semi-hard tooling for micro molding?
Soft or semi-hard tooling and CNC machined cavities are a great solution for non-critical larger parts, but are not ideal […] Read Moreabout Soft or Semi-hard tooling for micro molding?