My life was in the hands of my team.
February 3, 2023
Community Homepage Featured News Page Featured-
Hot Tech: The future of optics in healthcare
December 7, 2022
-
Micro mold design outsourcing. The key to performance.
November 8, 2022
-
Hot Tech: 3D printing for the mass market
October 31, 2022
-
Micro Mold Optics Basics (Webinar Transcript)
June 30, 2021
Hot Tech Sensors Converge: Why OEMs need to think EEG
Sensors Converge took place in Santa Clara, CA this June. The event brings together premier sensor tech engineers, and thinkers. In […] Read Moreabout Hot Tech Sensors Converge: Why OEMs need to think EEG
Did COVID change engineer communications?
The world’s best engineers rely on fast, consistent, accurate communication. But what happens when a global pandemic forces everyone to […] Read Moreabout Did COVID change engineer communications?
Advantages of additive manufacturing in micro-molding
Historically, additive manufacturing (AM) wasn’t precise enough to be used in micro molding. That has changed. The Fabrica 2.0 precision […] Read Moreabout Advantages of additive manufacturing in micro-molding
Hot Tech (MD&M West): EPRs in wearable medtech
MD&M West takes place annually in Anaheim. The event brings together premier MedTech engineers, and thinkers. In this special “hot tech” section, […] Read Moreabout Hot Tech (MD&M West): EPRs in wearable medtech
What is innovation? No, seriously…
Engineers in the medical space are solving complex problems and a company calling itself “innovative” doesn’t matter to them in […] Read Moreabout What is innovation? No, seriously…
Hot Tech (MedTech UK): Next-Gen Wearables
Medical Technology UK took place in Coventry, England this year at the world-famous Coventry Building Society Arena. The event attracts […] Read Moreabout Hot Tech (MedTech UK): Next-Gen Wearables
Molding glass optical components into larger structures at high temperature
After a webinar, I was asked by an engineer if a micro molder is able to mold, or overmold, glass […] Read Moreabout Molding glass optical components into larger structures at high temperature
Hot Tech (SPIE): Fabrication of platinum microstructures?
SPIE Photonics West in San Francisco always features the most exciting research in biomedical optics, biophotonics, industrial lasers, and is […] Read Moreabout Hot Tech (SPIE): Fabrication of platinum microstructures?
Can you use 3D Printing for Micro Molding?
Micro molding tight-toleranced and high-precision parts comes with fascinating challenges, specifically in prototyping. If a company isn’t careful this phase […] Read Moreabout Can you use 3D Printing for Micro Molding?
Staff from around the world, give back
Making 20,000 meals in a few hours sounds intense, and when you consider the overall impact, it’s also a very […] Read Moreabout Staff from around the world, give back
Contributor
Accumold partners are a strategic component in our success. That’s why we give them a voice right here.