Parts Categori: Cadre de montage / Insert

Description: This tiny 2 mm (.08″) diameter part contains a delicate fabric mesh. Accumold developed a custom system to articulate […] Read Moreabout Fabric Mesh Overmolding

Description:This part is molded in a multi cavity mold on continuous strip. The cavity-to-cavity variation averages between .0002″ (5 µm) […] Read Moreabout Lead Frame Molded Bobbin

Description: This part required delicate handling of the flex circuit during processing. Careful shut-offs on the mold were require to […] Read Moreabout Flex Circuit Overmolding

Description: Our challenge involved shutting off around the lead frame without interfering with the function of the part. Material: LCP […] Read Moreabout Lead Frame Molded Rotor

Description: This part is over molded on a lead strip then singulated and post-mold formed to final position. Material: Nylon […] Read Moreabout Reel-to-Reel Micro Molding

Description: We insert mold a plastic tip on the steel shaft in a micro-mold. Then we insert the shaft assembly […] Read Moreabout Insert Mold Lamp Capsule

Description:This open air package was designed with a very tight pitch between each lead. Shut-offs on this mold are very […] Read Moreabout Open Cavity Package – 100 Lead Quad Pack

Description:This lead frame is over-molded with PEEK. The diameter of the part is approx. 4mm. Material:PEEK Market Segment: Micro-moulage médical Core […] Read Moreabout Wearable Switch Component

Description:This part was run in a single cavity Micro-Mold® on a continuous lead frame. Dual lead frames were used and […] Read Moreabout Lead Frame Molded SO8 Package